FM-250A

BANDSAW

 HORIZONTAL BANDSAW

 

 

  • Heavy ribbed cast iron construction of saw frame and machine body.
  • Quick acting vise for 90 ํ to 45 ํ full mitering.
  • Easily cleaning removable chip tray.
  • Automatic stop for machine when stock is exhausted.
  • Efficient coolant system with built-in tank and pump.
  • Adjustable feed rate selector is equipped for saw frame approaching to workpiece and cutting feed too.

 

 

FM-916A

BANDSAW

 HORIZONTAL BANDSAW

 

 

  • One complete piece of fabricated steel plate of machine stand with wide and long chip dust box in front which easily collect all chips in this box and move out.
  • Special On-Off switch controls the fixed blade down feed which is presented on valve adjust knob to provide easy operation.
  • Built-in type of coolant tank direct inside stand, and has coolant liquid indicator right outside of stand.
  • Automatic stop for machine when stock is exhausted.
  • Quick acting vise with 90 ํ to 45 ํ full mitering.

 

 

VBS-1408

BANDSAW

VERTICAL BANDSAW

 

 

  • The electric panel showing at the top the step down transformer for low voltage controls, magnetic contactors with overloads, fuses etc for CSA electrical approval.
  • The yellow arrow points to the latching interlocked safety switch.  The blade wheel must be stopped before the latch will release to allow access. To the right is the operator panel on low voltage showing the keyed master switch, pilot light,
    E-stop and start buttons.
  • The transmission of the Fuho 1408 band saw.  The chip blower pump is in the lower right.

 

 

VBS-1610

BANDSAW

VERTICAL BANDSAW

 

 

  • The electric panel showing at the top the step down transformer for low voltage controls, magnetic contactors with overloads, fuses etc for CSA electrical approval.
  • The yellow arrow points to the latching interlocked safety switch.  The blade wheel must be stopped before the latch will release to allow access. To the right is the operator panel on low voltage showing the keyed master switch, pilot light, E-stop and start buttons.

 

 

VBS-2012

BANDSAW

VERTICAL BANDSAW

 

  • The electric panel showing at the top the step down transformer for low voltage controls, magnetic contactors with overloads, fuses etc for CSA electrical approval.
  • The yellow arrow points to the latching interlocked safety switch.  The blade wheel must be stopped before the latch will release to allow access.To the right is the operator panel on low voltage showing the keyed master switch, pilot light, E-stop and start buttons.
  • The transmission of the Fuho VBS-2012.  The air pump for the chip blower is in the lower right.
  • Showing the linear bar supports under the table on the power table feed models

 

 

Message Us!
close slider

Name

Email

Subject

Message