VBS-1408

BANDSAW

VERTICAL BANDSAW

 

 

  • The electric panel showing at the top the step down transformer for low voltage controls, magnetic contactors with overloads, fuses etc for CSA electrical approval.
  • The yellow arrow points to the latching interlocked safety switch.  The blade wheel must be stopped before the latch will release to allow access. To the right is the operator panel on low voltage showing the keyed master switch, pilot light,
    E-stop and start buttons.
  • The transmission of the Fuho 1408 band saw.  The chip blower pump is in the lower right.

 

 

VBS-1610

BANDSAW

VERTICAL BANDSAW

 

 

  • The electric panel showing at the top the step down transformer for low voltage controls, magnetic contactors with overloads, fuses etc for CSA electrical approval.
  • The yellow arrow points to the latching interlocked safety switch.  The blade wheel must be stopped before the latch will release to allow access. To the right is the operator panel on low voltage showing the keyed master switch, pilot light, E-stop and start buttons.

 

 

VBS-2012

BANDSAW

VERTICAL BANDSAW

 

  • The electric panel showing at the top the step down transformer for low voltage controls, magnetic contactors with overloads, fuses etc for CSA electrical approval.
  • The yellow arrow points to the latching interlocked safety switch.  The blade wheel must be stopped before the latch will release to allow access.To the right is the operator panel on low voltage showing the keyed master switch, pilot light, E-stop and start buttons.
  • The transmission of the Fuho VBS-2012.  The air pump for the chip blower is in the lower right.
  • Showing the linear bar supports under the table on the power table feed models

 

 

Message Us!
close slider

Name

Email

Subject

Message